Town Car V8-281 4.6L SOHC (1991)
8.
Apply Instant Adhesive (E8AZ-19554-A) to loose vinyl skin and foam (Figure 6).
9.
Install applique and pull cup.
10.
Install armrest/door. Check for binding between armrest and trim panel. If any resistance is felt due to rubbing against trim panel, then the armrest
must be shimmed to prevent future vinyl skin separation from the trim panel.
a.
Check gap between closed armrest/door and trim panel at front, middle and rear. Shim as required to obtain a minimum gap of 2 mm.
b.
Use suitable washers (three (3) maximum per screw) as shims between the armrest and the trim panel to eliminate binding (Figure 1). The
difference in the number of shims between adjacent screws should not exceed one (1); for example: two (2) at rear screw, one (1) at middle
screw, and none (0) at the front screw. Washers should be approximately 10 mm diameter and 1 mm thick; recommend using
E63OO21-S208 or similar washer.
PART NUMBER
PART NAME
E8AZ-19554-A
Instant Adhesive
E630021-S208
Washer
OTHER APPLICABLE ARTICLES: NONE
WARRANTY STATUS:
Eligible Under The Provisions Of Bumper To Bumper Warranty Coverage For 1991-94 Models, Basic Warranty Coverage For 1990 Models
OPERATION DESCRIPTION
TIME
950301A
Door Panel - Remove And
0.5 Hr.
Install And Repair - One
950301B
Door Panel - Remove And
0.9 Hr.
Install And Repair - Both
DEALER CODING
BASIC PART NO.
CONDITION CODE
7024140
41
ACES II
DEALERS MUST
CODE AGAINST
THE FULL BASE
NUMBER, DO
NOT USE 70
OASIS CODES: 107000, 112000
