lincoln Workshop Repair Guides

Lincoln Workshop Service and Repair Manuals

Recall - Hood Latch Replacement|Page 6272 > < Recall - Hood Latch Replacement
Page 2
background image

OPERATION DESCRIPTION

LABOR TIME

LABOR OPERATION/CODE

Install Hood Latch Assembly

0.3 Hrs.

Labor Operation 95S19B

Administrative Allowance

0.1 Hrs.

Misc. Expense Code "ADMIN"

Parts Requirements

Parts will not be direct shipped for this recall. Order your parts requirements through normal ordering processing channels.

PART NUMBER

DESCRIPTION

DEALER PRICE

F2AZ-16700-C

Hood Latch Assembly

$11.17

Parts prices current until next issue of Master Price Book. For latest prices, check or call your:

^

Order Processing Center

^

DOES II

^

Updated Price Book

Excess Stock Return

Excess stock returned for credit must have been purchased from Ford Customer Service Division in accordance with Policy Procedure Bulletin 4000.

Attachment III - Technical Instructions

Technical Instructions

Affected Vehicles:
1991-1992 Lincoln Town Car Hood Latch

Removal

1.

Open hood and remove the hood latch cable retainer.  Refer to illustration in the 1991 Town Car, Crown Victoria and Grand Marquis Shop
Manual in section 44-08.

 
2.

Remove the hood latch retaining screws and remove the hood latch assembly.

 
3.

Remove the one cable retaining screw and disengage the cable from the hood latch assembly.

Installation

1.

Reassemble the hood latch release cable to the hood latch assembly and install one retaining screw.  Tighten to 1.8-2.6N-m (1.5-2.1 lb-ft.)

 
2.

Position the latch to vehicle and install the two retaining screws.

 
Note that the hood latch may not fit because the locating pins on the new latch may not have corresponding holes in the radiator support.  In this event,
drive out the locating pins from the latch with a hammer and punch, bracing the latch over vice jaws so as not to distort the latch.  These pins are for
production assembly only.
 
Also note that in some cases the attaching screws may not fit. Reuse the original screws in this event.
 
3.

Adjust the hood latch as described in Shop Manual section 44-08.  Tighten the attaching screws to 9-14 N-m (7-10 lb-ft.).

Dealer Letter

RECALL NUMBER

95S19

Date: Sept., 1995

PARTS
AVAILABILITY

At Dealers By: as Req'd

0% of Parts Direct

Recall - Hood Latch Replacement|Page 6272 > < Recall - Hood Latch Replacement