Town Car V8-281 4.6L SOHC (1991)
3.
Remove the switch retaining screw with a T-15 TORX bit (Figure 3).
4.
Gently pry on the locking tab and lift switch assembly from pull-down unit (Figure 3).
a.
Rock switch slightly side-to-side to clear metal reinforcement plate, if necessary.
SWITCH - INSTALLATION
1.
Operate motor to position the striker at the open position.
a.
Position toggle switch up on new unit to match position of striker. This will assure that the toggle will be positioned between the two (2)
tabs on the striker when installed (Figure 3).
