Town Car V8-281 4.6L SOHC (1991)
Brake Bleeding: Service and Repair
With ABS
1.
Disconnect 55-pin plug from electronic control unit, then attach Anti-Lock Breakout Box/Bleeding Adapter tool No. T90P-50-ALA or equivalent
to wiring harness 55-pin plug.
2.
Place bleed/harness switch in bleed position.
3.
Turn ignition to On position, the red Off light should turn on.
4.
Push motor button on adapter down to start pump motor. The Red Off light will turn off and green On light will turn on. The pump motor will run
for 60 seconds once motor button is pushed.
5.
If pump motor is turns off before 60 seconds has elapsed, push abort button and pump motor will turn off.
6.
After 20 seconds of operation, push and hold valve button down. Hold valve button for 20 seconds, then release.
7.
Pump motor will continue to run an additional 20 seconds after valve button is released.
8.
Brake lines can be bled in a conventional manner in the following sequence:
a. Right rear.
b. Left front.
c. Left rear.
d. Right front.
