Town Car V8-281 4.6L SOHC (1991)
8.
Align switch mounting holes with corresponding holes in lock cylinder housing, then install two self tapping screws.
9.
Stick foam switch cover to switch.
10.
Install two switch electrical connectors to full engagement.
11.
Place airbag slip ring onto steering shift and install two retaining screws that attach slip ring to retainer plate, ensuring ground wire pigtail is
secured with lower retaining screw. Remove tape from slip ring.
12.
Connect slip ring/clockspring wire connector to column wiring harness.
13.
Install upper and lower shrouds and the steering wheel.
14.
Connect airbag module wire connector to slip ring connector and place airbag module on steering wheel, then install four attaching nuts. Torque
to 35-53 inch lbs.
15.
Connect battery ground cable.
16.
Rearm airbag system as described under MAINTENANCE PROCEDURES/AIRBAG SYSTEM DISARMING.
