Town Car V8-281 4.6L SOHC (1991)
HOT.
4.
Operate engine until normal operating temperature is reached. The transmission fluid temperature should be approximately 38-72°C (100-1 500
F). Do not make pressure check if transmission fluid is cold or too hot to touch.
5.
Set parking brake and place shift selector in NEUTRAL. With gauge tool in place and engine idling in NEUTRAL, the TV pressure should be
between 207 and 276 kPa (30 and 40 psi).
NOTE:Do not check or set TV pressure in PARK.
6.
If TV pressure meets specification in Step 5, remove gauge tool allowing cable to returnto its normal idle position. With engine still idling in
NEUTRAL, TV pressure must be at or near zero (less than 34 kPa (5 psi)).
7.
If TV pressure does not meet specification in either or both Steps 5 and 6, remove gauge tool and readjust cable as outlined under TV Cable
Adjustment-Self-Locking System.
8.
Check TV Pressure again. Refer to Steps 3 through 6.
9.
If TV pressure still does not meet specification, it will be necessary to modify adjustment as follows.
10.
Remove gauge tool and pry grooved pin out of grommet on throttle lever.
11.
Mark or me~sure location of plastic block on notched rod.
