Town Car V8-281 4.6L SOHC (1991)
Power Window Motor: Service and Repair
Rear Door Window Motor
Removal
1. Remove door trim panel and watershield. See: Body and Frame/Doors, Hood and Trunk/Doors
2. Disconnect battery ground cable. Disconnect motor wires at multiple connector.
3. Remove three 1/4-inch rivets attaching the motor bracket to inner panel. Use drift to knock out the center pins from each rivet. Using a 1/4-inch
diameter drill, drill out the remainder of the rivet. Use care not to enlarge sheet metal holes in the door inner panel.
4. Working through access hole, remove motor bracket from inner panel and rotate to gain access to three motor retaining screws.
5. Remove motor retaining screws and separate motor from bracket and cable drum housing.
6. Remove motor.
Installation
1. Position motor and drive to cable drum housing and motor mounting bracket. Install three motor screws. Tighten to 5.5-7.0 N-m (49-61 lb-in).
2. Install rivets retaining motor mounting bracket to inner panel (1/4-20 x 1/2 inch bolt and 1/4-20 nut and washer assemblies or equivalent metric
fasteners may be used).
3. Connect power window motor wiring and battery ground cable.
4. Check window operation, install watershield, door trim panel, and armrest. See: Body and Frame/Doors, Hood and Trunk/Doors
