Town Car V8-281 4.6L SOHC (1991)
Rear Door Window Regulator: Service and Repair
With Window Down and Inoperable
Removal
1. Remove door trim panel and watershield. See: Body and Frame/Doors, Hood and Trunk/Doors
2. Mark inner door panel and drill three holes 12.7mm (0.5 inch) as shown.
CAUTION:
Be careful not to drill through the mechanism behind inner door panel.
3. Remove retaining screws through holes.
4. Remove regulator assembly off mounting bracket through access hole.
CAUTION:
Be careful not to strike or scratch glass.
5. Remove motor assembly from drum housing and cover.
6. Raise glass to full-up position by hand and secure with a clamp.
7. Disconnect motor drive assembly.
8. Remove motor drive assembly.
9. Remove regulator.
Installation
1. Install regulator.
2. Install motor drive assembly through access hole.
3. Assemble motor drive assembly to drum housing and cover. Align mounting holes in motor with holes in drum housing and cover.
4. Align motor drive assembly to mounting bracket.
5. Install three retaining screws to mounting bracket. Tighten to 5.5-7.0 N-m (49-61 lb-in).
