lincoln Workshop Repair Guides

Lincoln Workshop Service and Repair Manuals

All Technical Service Bulletins for Control Assembly: > < Air Conditioning - Approved Flushing Procedures|Page 5522
Page 1
background image

Control Assembly: Customer Interest
ATC System - Erratic Operation

AIR CONDITIONING - AUTOMATIC TEMPERATURE CONTROL (ATC) - ERRATIC OPERATION - VEHICLES BUILT BEFORE 10/05/87
Article No. 88-2-3
LINCOLN-MERCURY: 1986-88 LINCOLN TOWN CAR
ISSUE:

Erratic operation of the ATC system may be caused by a loose vacuum hose at the vacuum motor. The loose hose allows vacuum to leak
causing the vacuum motor to divert the A/C output to the defroster nozzles instead of to the instrument panel registers. The vacuum hose may
loosen if it rubs on the left and right lower instrument panel insulators.

ACTION:

To correct this, rework the right and left lower instrument panel insulators using the following service procedure.

FIGURE 11

1.

Rework left insulator by trimming a 3" x 1" notch along the shaded edge as shown in Figure 11.

2.

Rework right insulator by trimming the shaded corner as shown in Figure 11.

NOTE:

The 45 degree trim line is located 1.5 inches from corner of insulator.

OTHER APPLICABLE ARTICLES: None
WARRANTY STATUS: Eligible Under Basic Warranty Coverage
OPERATION: 880203A
TIME:

0.3 Hr. DLR. CODING: Basic Part No. 7004320
Code:

35

All Technical Service Bulletins for Control Assembly: > < Air Conditioning - Approved Flushing Procedures|Page 5522