Town Car V8-302 5.0L (1987)
5.
Remove the vacuum supply hose from the EGR valve nipple. Plug the hose.
6.
Disconnect the 9G428 EVP sensor electrical connector mounted on top of the 9H473 valve.
7.
Start engine, idle with transmission in NEUTRAL, and observe the engine idle speed. If necessary, adjust idle speed to the emission decal
specification.
8.
Slowly apply 5-10 inches of mercury vacuum to the EGR valve vacuum nipple using a hand vacuum pump.
9.
When vacuum is applied to the EGR valve and any of the following occur, replace the valve:
^
Engine does not stall.
^
Idle speed does not drop more than 100 rpm.
^
Idle speed does not return to normal (+/- 25 rpm) after the vacuum is removed.
10.
Reconnect the idle air bypass valve electrical connector.
11.
Unplug and reconnect the EGR vacuum supply hose.
12.
Reconnect the EVP sensor electrical connector.
13.
The EGR valve is OK, REPLACE EVP sensor if the Continuous Code 32 was present. If the Continuous Code 32 was not present, refer to the
Diagnostic Routines in Section 2.
1986 Quick Test: Continuous Self-Test 6.0
EEC IV - Quick Test - All Engines
18-13
