Town Car V8-302 5.0L (1987)
7.
Using the power window switch, raise the window regulator. Slide the regulator forward and install the main glass front arm into the "C" channel.
8.
Position the new cam on the regulator arm.
9.
Push the glass to the full-up position.
CAUTION:
MAKE SURE THE GLASS IS WITHIN THE DIVISION BAR RUN AND THE REAR DOOR FRAME.
10.
Prop the glass in the full-up position.
11.
Install the vent glass and prop up.
12.
Loosely install two (2) 1/4 inch-20 x 1/2 screw and washer assemblies to position the regulator.
13.
Remove main door glass prop.
14.
Install the vent arm guide in the vent glass bracket "C" channel.
15.
Remove vent glass prop.
16.
Position the vent glass to the full-up position.
CAUTION:
MAKE SURE THE REAR EDGE OF THE GLASS IS SET WITHIN THE DIVISION BAR BEFORE MOVING THE GLASS TO
THE FULL-UP POSITION.
17.
Position the front run retainer into the door. Loosely install the screw and washer assemblies.
18.
Insert the glass run into the retainer to the belt.
19.
Repeat Steps 17 and 18 for the rear run retainer.
20.
With the glass in the full-up position, install the cam screw and washer assemblies. Reset to the scribed marks made during removal.
21.
Install the equalizer arm with two (2) nut and washer assemblies. Reset to the scribed marks made during removal.
22.
Install six rivets or six 1/4 inch-20 x 1/2 bolts to hold the regulator to the door panel.
23.
Loosely assemble the three (3) division bar attachments:
^
Belt bracket
^
Bottom of door
^
Door "A" frame
24.
Slowly lower the vent glass and door glass to the full-down position.
25.
Adjust the door and vent glass.
26.
Cycle the window to check for proper operation.
27.
Clean rivets from the bottom of inner door panel.
28.
Clean the glass.
29.
Install the watershield, trim panel and armrest.
30.
Repeat Steps 1 through 29 on the other side of the vehicle.
PART NUMBER
PART NAME
CLASS
E8VY-54214A76-A
Roller-Pkg. of 2
C
E8VY-54234B18-A
Cam-Right Hand
B
E8VY-54234B19-A
Cam-Left Hand
B
