lincoln Workshop Repair Guides

Lincoln Workshop Service and Repair Manuals

Front Door Glass - Will Not Lower All The Way|Page 7150 > < Front Door Glass - Binding/Groaning Noise|Page 7145
Page 1
background image

Window Regulator: Customer Interest
Front Door Glass - Will Not Lower All The Way

GLASS - FRONT DOOR - GLASS WILL NOT GO ALL THE WAY DOWN

Article No. 88-13-1

LINCOLN-MERCURY: 1980-88 LINCOLN TOWN CAR

ISSUE:

Front door glass that stays about 1/4" (6 mm) above the door glass belt line when the window is in the full down position may be caused by
the window regulator downstop. The window regulator downstop may be about 5/32" (4 mm) too long which will not allow the glass to
travel to the full down position.

FIGURE 1

ACTION:

To correct this, grind 5/32" (4 mm) off the window regulator downstop to increase the window travel. Refer to the following service
procedure.

1.

Position the front door window to the fully closed position.

2.

Remove the front door trim panel and watershield.

3.

Remove the front door window regulator.

4.

Grind 5/32" (4 mm) from the window regulator downstop, Figure 1.

5.

Remove any burrs around the downstop.

6.

Reinstall the front door window regulator.

7.

Reinstall the front door watershield and trim panel.

OTHER APPLICABLE ARTICLES: None
WARRANTY STATUS: Eligible Under Basic Warranty Coverage
OPERATION: 881301A - One window

Front Door Glass - Will Not Lower All The Way|Page 7150 > < Front Door Glass - Binding/Groaning Noise|Page 7145