Town Car V8-4.6L (2008)
Keyless Entry Transmitter: Testing and Inspection
Remote Keyless Entry Transmitter Programming
REMOTE KEYLESS ENTRY TRANSMITTER PROGRAMMING
NOTE:
-
All remote keyless entry (RKE) transmitters are programmable and must be set at the same time.
-
Programming of the RKE transmitters can be accomplished using a scan tool or by carrying out the following steps:
1. Turn the key from OFF to RUN 8 times within 10 seconds, ending in RUN. The locks then lock and unlock, confirming program mode has been
entered.
2. Press any button on each RKE transmitter to be programmed. The doors lock and unlock to confirm that each RKE transmitter has been
programmed.
3. If additional RKE transmitters are to be programmed, repeat Step 2 within 7 seconds. If more than 7 seconds have elapsed, the entire procedure
must be repeated.
4. To exit program mode, wait at least 7 seconds or turn the ignition key to the OFF position.
5. Wait at least 20 seconds after turning the key to the OFF position, or after the last RKE transmitter is programmed, to activate a RKE transmitter
for testing and verification.
