Town Car V8-4.6L (2008)
25. With the locking pins aligned and the driver air bag module positioned to the steering wheel, push inward seating the 4 locking pins to the spring
clip.
-
An audible click should be heard when the driver air bag module locking pins are seated in place to the spring clip. When the 4 locking pins
are seated in place, there should be an even uniform gap between the driver air bag module trim cover and the steering wheel.
26. WARNING: Remove restraint system diagnostic tools from the vehicle prior to road testing. If tools are not removed, the supplemental
restraint system (SRS) device may not deploy in a crash. Failure to follow this instruction may result in serious personal injury or death
in a crash and possibly violate vehicle safety standards.
Make sure all restraint system diagnostic tool(s) that may have been installed during the repair have been removed from the vehicle and all SRS
components are connected.
27. Turn the ignition switch from OFF to ON.
28. Install the RCM fuse 2 (10A) to the CJB and install the cover.
29. WARNING: Make sure no one is in the vehicle and there is nothing blocking or placed in front of any air bag module when the battery is
connected. Failure to follow these instructions may result in serious personal injury in the event of an accidental deployment.
Connect the battery ground cable.
30. Prove out the SRS as follows:
Turn the ignition key from ON to OFF. Wait 10 seconds, then turn the key back to ON and visually monitor the air bag warning indicator with the
air bag modules installed. The air bag warning indicator will light continuously for approximately 6 seconds and then turn off. If an air bag SRS
fault is present, the air bag warning indicator will:
