Town Car V8-4.6L (2008)
12. Check to make sure the index marks on the outboard track C-channel and plastic-coated slide are still in alignment.
-
The index marks on the outboard track C-channel and plastic-coated slide must align at this step. If the index marks do not match up, repeat
Steps 1 through 11.
13. Remove the bolt and slide the SRS seat position sensor magnet assembly to disengage and remove.
14. Check to make sure the index marks on the inboard track C-channel and plastic-coated slide are still in alignment.
15. NOTE: When assembled, a small gap between one of the gears and the drive tube may exist.
Assemble the seat track motor assembly, upper support assembly and inboard track together.
1
Align the drive tube to the motor stub shaft. Tap the nose of the inboard track gear toward the seat track motor stub shaft.
-
Positioning a block of metal or wood behind the motor gear can aid assembly.
2
While tapping the parts together, simultaneously engage the front and rear lift links to the inboard track.
-
When the lift links are up against the inboard track, with the bushings through the hole and seated, the drive tube is fully engaged.
