Town Car V8-4.6L (2008)
Removal and Installation
All vehicles
1. Apply pressure to the lower front portion of the rear seat cushion assembly. Push the rear seat cushion rearward to disengage the rear seat cushion
front retainers.
Vehicles with rear heated seats
2. Label and disconnect the electrical connectors.
All vehicles
3. Remove the 2 nuts and the rear seat backrest.
-
To install, tighten to 55 Nm (41 lb-ft).
4. WARNING: The retaining wires in the rear seat cushion foam pad and frame, and rear seat backrest foam pad and frame must be fully
seated in the retainer brackets to prevent the seat backrest and seat cushion from sliding forward in the event of a crash. Failure to follow
these instructions may increases the risk of serious personal injury or death in a crash.
NOTE: Make sure the safety belt webbing is not twisted and the safety belts and buckles are accessible to the occupants.
To install, reverse the removal procedure.
