Town Car V8-4.6L (2008)
Removal and Installation
1. Drain the cooling system.
2. Remove the bolt and position aside the power steering reservoir.
^
To install, tighten to 10 Nm (89 lb-in).
3. Disconnect the degas bottle overflow hose and supply hose.
4. Remove the bolt and the degas bottle.
^
To install, tighten to 10 Nm (89 lb-in).
5. Disconnect the upper radiator hose and position aside.
6. Detach the transmission cooler tubes from the cooling fan motor and shroud.
7. Disconnect the cooling fan motor electrical connector.
8. NOTE: Position the lower radiator hose away from the cooling fan motor and shroud.
Remove the 2 bolts and the cooling fan motor and shroud assembly.
^
To install, tighten to 7 Nm (62 lb-in).
9. To install, reverse the removal procedure.
10. Fill and bleed the cooling system.
