Town Car V8-4.6L (2008)
Engine Temperature Sensor: Service and Repair
Removal and Installation
1. Disconnect the battery ground cable.
2. Rotate the tensioner clockwise and remove the accessory drive belt from the generator pulley.
3. Loosen the 2 lower generator bolts.
-
To install, tighten to 25 Nm ( 18 lb ft )
4. Remove the 2 generator bracket bolts and position the generator and bracket aside.
-
To install, tighten to 10 Nm ( 89 ln in )
5. Disconnect the Cylinder Head Temperature (CHT) sensor electrical connector.
