Town Car V8-4.6L (2008)
3. Remove and discard the lower arm-to-axle nut and bolt.
4. Remove the lower arm-to-frame bolt, flagnut and the lower arm.
^
Discard the flagnut and bolt.
Installation
1. NOTE: The rear suspension lower arms are interchangeable from side-to-side, with OUTBOARD stamped on one side of the arms for positioning
during installation.
Position the lower arm and loosely install the lower arm-to-frame bolt and flagnut.
2. Loosely install the lower arm-to-axle nut and bolt.
3. Before tightening the fasteners, use a suitable jack to raise the suspension until the distance between the lip of the fender and the center of the
wheel hub is equal to the measurement taken in the removal procedure.
4. Tighten the lower arm-to-frame bolt to 150 Nm (111 lb-ft).
5. Tighten the lower arm-to-axle bolt to 150 Nm (111 lb-ft).
6. Install the wheel and tire.
