Town Car V8-4.6L (2008)
5. NOTE: Use the holding feature to prevent the stud from turning while removing the nut.
Remove the nut and detach the outer tie rod from the wheel knuckle.
^
To install, tighten to 80 Nm (59 lb-ft).
6. NOTE: Use the holding feature to prevent the stud from turning while removing the nut.
Remove and discard the stabilizer bar link upper nut.
^
To install, tighten to 63 Nm (46 lb-ft).
7. NOTE: Use the holding feature to prevent the stud from turning while removing the nut.
Remove the stabilizer link lower nut and the stabilizer bar link.
^
Discard the nut.
^
To install, tighten to 55 Nm (41 lb-ft).
8. Detach the wheel speed sensor wiring harness retainer from the steering knuckle.
9. NOTE: Use the holding feature to prevent the stud from turning while removing the nut.
Remove and discard the upper ball joint nut.
^
To install, tighten to 150 Nm (111 lb-ft).
10. NOTE: Use the holding feature to prevent the stud from turning while removing the nut.
Remove the lower ball joint nut and then remove the wheel knuckle.
^
Discard the nut.
^
To install, tighten to 150 Nm (111 lb-ft).
11. If necessary, remove the 4 bolts and the wheel bearing and wheel hub.
^
To install, tighten to 120 Nm (89 lb-ft).
12. To install, reverse the removal procedure.
13. Check and, if necessary, align the front end.
