Town Car V8-4.6L (2008)
Position the sensor into the new cradle by inserting the hinge end of the sensor into the hook end of the cradle and pushing the opposite end of the
sensor down onto the cradle.
2. NOTICE: Metal scrapers may damage the wheel. Use only plastic or non-metallic scrapers to remove the cradle adhesive strip residue.
NOTE: The sensor and cradle must be installed in the drop well of the wheel, 180 degrees from the valve stem.
Using wheel and tire cleaner, clean the area where the sensor and cradle are to be installed.
3. NOTE: The sensor and cradle must be positioned with the hinge side of the sensor on the RH side when viewed from the curb side (beauty side)
of the wheel.
NOTE: The sensor has raised markings indicating how to position the sensor.
Remove the adhesive tape liner from the cradle and position the sensor and cradle into the wheel drop well 180 degrees from the valve stem. Click
here to view a video version of this procedure.
4. Install the tapered end of the strap through the opening of the cradle on the hinge side of the sensor. This will position the worm gear on the
locking clip side of the sensor. Click here to view an animated version of this procedure.
5. NOTICE: Steel wheels have a "high spot" along their circumference. Make sure the strap and sensor are mounted at the lowest spot possible to
