Town Car V8-4.6L SOHC VIN W (1999)
Multifunction Electronic Control Module: Service and Repair
Driver Door Module
REMOVAL
1. Disconnect the battery ground cable.
CAUTION
^
Prior to removal of module, it is necessary to upload module configuration information to New Generation STAR (NGS) Tester. This
information needs to be downloaded into the new module once installed.
^
Electronic modules are sensitive to electrical charges. If exposed to these charges, damages may result.
2. Remove the driver door trim panel.
3. Disconnect the electrical connectors from the Driver Door Module (DDM).
4. Remove the DDM.
INSTALLATION
1. To install, reverse the removal procedure.
CAUTION: Once the new module is installed, it is necessary to download the module configuration information from New Generation STAR
(NGS) Tester into the new module.
NOTE: When the battery is disconnected and reconnected, some abnormal drive symptoms may occur while the vehicle relearns its adaptive
strategy. The vehicle may need to be driven 16 km (10 miles) or more to relearn the strategy.
