Town Car V8-4.6L SOHC VIN W (1999)
2. Position the anti-rattle clip behind the rear disc brake caliper anchor plate.
3. CAUTION: To prevent interference with rear disc brake caliper operation, install only the correct caliper bolt.
NOTE: When installed, the locator notch on the brake pads will be located at the upper end of the rear disc brake caliper.
Install the rear disc brake caliper.
4. Install the rear wheel brake hose.
-
Connect the brake hose and install the caliper flow bolt.
[] Use new copper washers.
5. Bleed the disc brake caliper.
6. NOTE: After the vehicle is on the ground if equipped with air suspension, reactivate the system by turning on the air suspension switch.
Install the wheel and tire assembly.
7. Verify correct brake operation.
