Town Car V8-4.6L SOHC VIN W (1999)
5. Inspect the disc brake caliper.
-
If leaks or damaged boots are found, disassembly is required.
Installation
1. CAUTION: Make sure guide pin boots are properly seated or damage to guide pins can occur.
NOTE: Tighten the lower caliper bolt first.
Install the disc brake caliper.
1
Install the disc brake caliper.
2
Install the disc brake caliper bolts.
2. Install the front brake hose.
-
Use new copper washers; connect the front brake hose.
-
Install the front brake hose bolt.
3. Bleed the caliper.
4. NOTE: After the vehicle is on the ground, if equipped with air suspension, reactivate the system by turning on the air suspension switch.
Install the wheel and tire assembly.
5. Fill the brake master cylinder reservoir with clean High Performance DOT 3 Brake Fluid C6AZ-19542-AB or equivalent DOT 3 fluid meeting
Ford specification ESA-M6C25-A. If DOT 3 is not available, use DOT 4 Brake Fluid meeting Ford specification SAE-J-1704-DOT 4. Install
brake. master cylinder filler cap.
6. Inspect the brake system operation.
