Air Bag Disposal for Town Car V8-46L SOHC VIN W (1999)
3. Push in on the two glove compartment door tabs and position downward.
4. Disconnect the passenger air bag module.
1
Disconnect the passenger air bag module electrical connector.
2
Remove the passenger air bag module retaining bolts.
5. Release the upper retaining clips from the passenger air bag module by pushing on it from inside the instrument panel opening, then remove it.
CAUTION: Do not handle the passenger air bag module by grabbing the edges of the deployment doors.
INSTALLATION
WARNING:
-
Always wear safety glasses when repairing an air bag supplemental restraint system (SRS) vehicle and when handling an air bag module.
This will reduce the risk of injury in the event of an accidental deployment.
-
Carry a live air bag module with the air bag and deployment door pointed away from your body. This will reduce the risk of injury in the
event of an accidental deployment.
-
Never probe the connectors on the air bag module. Doing so can result in air bag deployment which can result in personal injury.
NOTE:
-
Repair is made by installing a new part only. If the new part does not correct the condition, install the original part and perform the diagnostic
procedure again.
-
Make sure to tighten the retaining bolts to specification.
