Town Car V8-4.6L SOHC VIN W (1999)
3. Using the special tools, press the ball joint from the suspension lower arm.
INSTALLATION
1. NOTE: When installing a new front suspension lower ball joint, the protective cover must be left in place during installation to protect the ball
joint seal. It may be necessary to cut off the end of the cover to allow it to pass through the receiving cup.
Using the special tools, install the lower ball joint.
2. Discard the protective cover and check the front suspension lower ball joint to make sure it is fully seated in the front suspension lower arm and
the ball joint seal is free of cuts or tears.
3. Install the spindle.
4. Check wheel alignment. Adjust as necessary.
