lincoln Workshop Repair Guides

Lincoln Workshop Service and Repair Manuals

ABOUT US
Electronic Pressure Control Solenoid <--> [Pressure Regulating Solenoid, A/T]|Service and Repair|Page 4072 > < Engine Controls - General PCM Programming Procedures|Page 4065

Town Car V8-4.6L SOHC VIN W (1999)

  • Transmission and Drivetrain
  • Actuators and Solenoids - Transmission and Drivetrain
  • Actuators and Solenoids - A/T
  • Electronic Pressure Control Solenoid <--> [Pressure Regulating Solenoid, A/T]
  • Component Information
  • Service and Repair

Page 1
background image

Electronic Pressure Control Solenoid: Service and Repair

Removal 

1. Remove the manual control lever.

2. CAUTION:  Do not pull on the plastic lead frame. This may cause damage to the connector ends. Carefully pry up on the locking tabs to

disconnect the solenoids. Disconnect the molded lead frame from the solenoids. 

Disconnect the molded lead frame from the solenoids.
1. Disconnect the shift solenoid SSA and SSB.
2. Disconnect the Torque Converter Clutch (TCC).
3. Disconnect the Electronic Pressure Control (EPC) solenoid.
4. Disconnect the bulkhead inter-connector.

3. Remove the EPC solenoid.

Installation 

1. Install the EPC solenoid.

  • Transmission and Drivetrain
  • Actuators and Solenoids - Transmission and Drivetrain
  • Actuators and Solenoids - A/T
  • Electronic Pressure Control Solenoid <--> [Pressure Regulating Solenoid, A/T]
  • Component Information
  • Service and Repair

Electronic Pressure Control Solenoid <--> [Pressure Regulating Solenoid, A/T]|Service and Repair|Page 4072 > < Engine Controls - General PCM Programming Procedures|Page 4065