Town Car V8-4.6L VIN V Flex Fuel (2006)
Antenna Cable: Service and Repair
Antenna Lead-In Cable - Rear
ANTENNA LEAD-IN CABLE - REAR
Removal and Installation
CAUTION: The antenna lead-in cable is not removable from the wiring harness. If a new cable is being installed, leave the existing cable in the
wiring harness. Install a new cable on top of the body main wiring harness and secure it with wire ties. Do not cut into the wiring harness to
remove the existing antenna lead-in cable. Tie back or insulate the old cable ends to keep them from causing noise.
1. Remove the parcel shelf.
2. Remove the RH lower C-pillar trim panel.
-
Remove the pin-type retainers.
-
Position the insulation aside.
3. Remove the RH lower A-pillar trim panel.
4. Remove the RH B-pillar trim panel.
5. Disconnect the antenna lead-in cable at the A-pillar.
6. Lower the RH rear corner of the headliner.
