Town Car V8-4.6L VIN V Flex Fuel (2006)
2. NOTE: This step is critical in getting the inboard and outboard tracks in alignment. Otherwise, when installing the seat in vehicle, the holes in the
track mounting ears will not align to the holes in the floor pan and the seat track may prematurely fail due to binding. Position the new and old seat
track motor assembly side by side.
Position the new seat track motor assembly stub shaft flat spots (splines) in the same position as the old seat track motor assembly flat spots. If
necessary, apply power and ground to the new seat track motor electrical connector as shown during removal to obtain the same position.
3. NOTE: The front and rear height adjustment gears do not have to mesh with the seat track motor assembly gears at the same teeth as when
disassembled.
Install the seat track motor assembly to the upper support assembly.
1
NOTE: Make sure the motor is positioned right side up.
Install the seat track motor assembly pivots through the front and rear height adjustment gear brackets.
-
Apply multi-purpose grease to the motor pivots.
2
Mesh the seat track motor assembly gears to the front and rear height adjustment gears.
-
There should not be a gap between the upper support assembly gears and the seat track motor assembly housing.