Town Car V8-4.6L VIN V Flex Fuel (2006)
16. Remove the IP bolt.
^
To install, tighten to 12 Nm (9 ft. lbs.).
17. Remove the IP retaining bolt.
^
To install, tighten to 12 Nm (9 ft. lbs.).
18. Pull the IP slightly rearward and retain it using a small block of wood.
19. Disconnect the parking brake release vacuum hose from the parking brake release control motor.
20. Disconnect the electrical connector from the parking brake switch.
21. Disconnect the front parking brake cable and conduit from the parking brake control.
22. Remove the 3 parking brake control bolts.
^
To install, tighten to 30 Nm (22 ft. lbs.).
23. Remove the parking brake control.
24. To install, reverse the removal procedure.
^
Adjust the parking brake cable tension. For additional information, refer to Parking Brake Cable Adjustment.
