Town Car V8-4.6L VIN V Flex Fuel (2006)
^
To install, tighten to 28 Nm (21 ft. lbs.).
5. Disconnect the wiring harness bracket and position it aside.
6. Pull the brake master cylinder forward and position it aside.
7. Remove the pin-type retainers and the instrument close-out panel.
8. Remove the brake booster push rod retaining pin cover, retaining pin, washer, bushing and switch.
^
Slide the booster push rod off the pedal pin.
9. Remove the nuts and the power brake booster.
^
To install, tighten to 28 Nm (21 ft. lbs.).
10. CAUTION: The brake switch must be positioned with the closed hole away from the brake pedal arm and the open hole toward the brake pedal
arm.
NOTE: The brake booster input rod must be correctly oriented during installation.
To install, reverse the removal procedure.
