Town Car V8-4.6L VIN V Flex Fuel (2006)
Oil Pressure Sender: Service and Repair
Oil Pressure Sender
Oil Pressure Sender
Removal and Installation
1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to Maintenance/Service and Repair.
2. Disconnect the battery ground cable. For additional information, refer to Battery.
3. Disconnect the oil pressure sensor electrical connector and remove the oil pressure sensor.
^
To install, tighten to 14 Nm (10 ft. lbs.), then tighten an additional 180 degrees.
4. To install, reverse the removal procedure.
