Town Car V8-4.6L VIN V Flex Fuel (2006)
Water Pump: Service and Repair
Coolant Pump
Material
Removal and Installation
1. Drain the cooling system.
2. Loosen the 4 coolant pump pulley bolts.
3. Remove the accessory drive belt. For additional information, refer to Drive Belts, Mounts, Brackets and Accessories.
4. Remove the 4 bolts and the coolant pump pulley.
^
To install, tighten to 25 Nm (18 ft. lbs.).
5. Remove the 4 bolts and the coolant pump.
^
Discard the 0-ring seal.
^
To install, tighten to 25 Nm (18 ft. lbs.).
6. CAUTION: Do not rotate the coolant pump housing once installed in the engine. Damage to the O-ring seal can occur, causing the coolant pump
