Town Car V8-4.6L VIN V Flex Fuel (2006)
Daytime Running Lamp: Testing and Inspection
Inspection and Verification
INSPECTION AND VERIFICATION
1. Verify the customer concern by operating the daytime running lamps (DRL) following these steps:
1
Place the ignition switch in the RUN position.
2
Place the headlamp switch in the OFF position.
3
Apply and hold the brake pedal.
4
Place the transmission in any gear other than PARK.
5
If the DRL does not operate, make sure the lighting control module (LCM) is configured for DRL before proceeding to the next step.
2. Verify the high beam operation.
-
Place the headlamp switch in the HEADLAMPS ON position.
-
Place the multifunction switch in the HIGH BEAM position.
-
If the high beams do not operate correctly, refer to Headlamp to continue diagnosis of the high beam headlamps.
-
If the high beams operate correctly and the DRL operation is incorrect, install a new LCM. Test the system for normal operation.
