Town Car V8-4.6L VIN V Flex Fuel (2006)
^
Drain the fluid into a suitable container.
^
Discard the O-ring seals.
4. Remove the pressure line-to-engine nut.
^
To install, tighten to 7 Nm (62 inch lbs.).
5. Disconnect the electrical connector from the power steering pressure switch.
6. Disconnect the pressure line-to-pump fitting.
^
Discard the Teflon O-ring seal.
-
To install, tighten to 65 Nm (48 ft. lbs.).
7. NOTE: When connecting a fitting with an O-ring seal, a new seal must be installed.
To install, reverse the removal procedure.
^
Using the special tool, install an O-ring seal over the fitting.
^
Fill and leak check the system.
8. If equipped, turn the air suspension service switch to the ON position.
