lincoln Workshop Repair Guides

Lincoln Workshop Service and Repair Manuals

Spring Lock Couplings|Page 4003 > < Spring Lock Couplings|Page 4001
Page 1
background image

Fuel Line Coupler: Service and Repair
Quick Connect Coupling

QUICK CONNECT COUPLING

Disconnect - Type I

WARNING:

-

Do not carry lighted tobacco or open flame of any type when working on or near any fuel-related components. Highly flammable vapors
are always present and can ignite. Failure to follow these instructions may result in personal injury.

-

Do not carry personal electronic devices such as cell phones, pagers or audio equipment of any type when working on or near any
fuel-related components. Highly flammable mixtures are present and may be ignited. Failure to follow these instructions can result in
personal injury.

CAUTION:

-

If the liquid or vapor tube is damaged (torn, holes or delaminated), the affected tube assembly must be replaced with a new tube
assembly. Do not use aftermarket sleeving. Do not re-adhere loose sleeving material.

-

When reusing liquid or vapor tube connectors, make sure to use compressed air to remove any foreign material from the connector
retaining clip area before separating from the tube. Apply clean engine oil to the end of the tube before inserting the tube into the
connector.

-

Fuel injection equipment is manufactured to very precise tolerances and fine clearances. It is therefore essential that absolute cleanliness
is observed when working with these components. Always install blanking plugs to any open orifices or tubes.

1. Disconnect the quick connect coupling from the tube.

-

Press the quick connect coupling release button and separate the quick connect coupling from the tube.

Connect - Type I

1. CAUTION:  Make sure the tube clicks into place when installing into the quick connect coupling. To make sure that the tube is fully

seated, pull on the tube.

NOTE:  Apply clean engine oil to O-ring seals.

Connect the quick connect coupling onto the tube until fully seated.

Disconnect - Type II

WARNING:

-

Do not carry lighted tobacco or open flame of any type when working on or near any fuel-related components. Highly flammable vapors
are always present and can ignite. Failure to follow these instructions may result in personal injury.

-

Do not carry personal electronic devices such as cell phones, pagers or audio equipment of any type when working on or near any

Spring Lock Couplings|Page 4003 > < Spring Lock Couplings|Page 4001