Town Car V8-4.6L VIN V Flex Fuel (2006)
2
Push down, pivoting the electrical connector retainer and release the electrical connector retainer.
3
Pull out, disconnecting the vehicle harness end of the connector from the component end.
10. Remove the 2 passenger air bag module bolts.
11. CAUTION: Do not handle the passenger air bag module by grabbing the edges of the deployment doors.
Placing a hand in the glove compartment opening, push the passenger air bag module out from the instrument panel.
-
Release the retaining clips and alignment pins from the instrument panel. The retaining clips are located at the upper LH and RH corners, and
the alignment pins at the lower LH and RH corners of the passenger air bag module deployment door.
Installation
1. Make sure the J-clips on the back of the passenger air bag module are fully seated into the slots.
2. Make sure the retaining clips on the back of the passenger air bag module are fully seated onto the ears.
3. CAUTION: Do not handle the passenger air bag module by grabbing the edges of the deployment doors.
Install the passenger air bag module into the instrument panel.
-
Make sure the 2 retaining clips are fully seated into the instrument panel. The passenger air bag module should have a flush fit and finish up
against the instrument panel.
4. Install the 2 passenger air bag module bolts.
-
Tighten to 9 Nm (80 lb-in).
5. Connect the passenger air bag module electrical connector.
6. Connect the glove compartment isolator. Close the glove compartment.
