Town Car V8-4.6L VIN V Flex Fuel (2006)
4. Remove the 2 seat track front bolts.
-
To install, tighten to 25 Nm (18 lb-ft).
5. Remove the 2 seat track rear covers.
6. Remove the 2 seat track rear nuts.
-
To install the inboard nut, tighten to 80 Nm (59 lb-ft).
-
To install the outboard nut, tighten to 25 Nm (18 lb-ft).
7. Tilt the seat forward enough to separate the front center safety belt and tongue anchor from the mounting stud and seat.
8. Route the safety belt and tongue through the seat cushion opening and remove the assembly.
9. NOTE:
-
When installing, make sure the safety belt anchor is in place on the rear inboard stud before tightening the nut.
-
Make sure the safety belt and tongue or safety belt buckle are accessible to the passenger after installation.
-
Make sure the safety belt webbing is not twisted prior to installation.
To install, reverse the removal procedure.
10. Repower the SRS.
11. Check the active restraints for correct operation.
