Town Car V8-4.6L VIN V Flex Fuel (2006)
3. Depower the SRS.
Driver seat only
4. Disconnect the electrical connector.
5. Remove the nut and safety belt buckle.
-
Route the safety belt buckle out from the seat cushion opening.
-
To install, tighten to 40 Nm (30 lb-ft).
Passenger seat only
6. Disconnect the electrical connector.
7. Remove the nut and safety belt buckle with belt tension sensor.
-
Route the safety belt buckle with belt tension sensor out from the seat cushion opening.
-
To install, tighten to 40 Nm (30 lb-ft).
All safety belt buckles
8. NOTE: Make sure the safety belt buckle is accessible to the passenger after installation.
To install, reverse the removal procedure.
9. Repower the SRS.
10. Check the active restraints for correct operation.
