Town Car V8-4.6L VIN V Flex Fuel (2006)
Seat Belt Buckle: Service and Repair
Safety Belt Buckle - Rear
SAFETY BELT BUCKLE - REAR
Removal and Installation
WARNING: All safety belt assemblies (including retractors, belt tension sensor (BTS), if equipped, buckles, shoulder belt height adjusters [if
equipped], child safety seat tether attachments and attaching hardware) should be inspected after every collision. All new belt assemblies
should be installed unless a qualified technician finds the assemblies show no damage and operate correctly. Belt assemblies not in use during a
collision should also be inspected and new assemblies installed if either damage or incorrect operation is noted. Failure to follow these
instructions could increase the risk of injury in collisions.
NOTE: The RH safety belt buckle is a part of the rear center safety belt retractor assembly.
1. Remove the rear seat cushion.
2. Remove the bolt and safety belt buckle assembly.
-
To install, tighten to 48 Nm (35 lb-ft).
3. NOTE: Make sure the safety belts and the safety belt buckles are routed correctly and are placed on the seat cushion.
To install, reverse the removal procedure.
4. Check the active restraint system for correct operation.
