Town Car V8-4.6L VIN V Flex Fuel (2006)
3. Connect the electrical connector.
4. WARNING: The tightening torque of the air bag side impact sensor retaining bolts is critical for correct system operation.
NOTE: The side impact sensor bolts must be install in the sequence shown.
Install the side impact sensor with bracket.
1
Position the side impact sensor with bracket.
2
Install the bolt.
-
Tighten to 12 Nm (9 lb-ft).
3
Install the bolt.
-
Tighten to 12 Nm (9 lb-ft).
4
Connect the electrical connector.
5. Install the secondary safety belt guide screw.
6. Install the upper and lower B-pillar trim panels.
7. Install the safety belt anchor and bolt.
-
Tighten to 40 Nm (30 lb-ft).
8. Install the safety belt anchor bolt cover.
9. Install the D-ring and bolt.
-
Tighten to 40 Nm (30 lb-ft.
10. Repower the SRS.
11. Check the active restraint system for correct operation.
