Town Car V8-4.6L VIN V Flex Fuel (2006)
18. Separate the OCS components from the seat cushion frame.
1
Release the pressure sensor hose.
2
Slide the pressure sensor off the bracket.
3
Cut the tie straps
4
CAUTION: Do not oversize the seat cushion frame holes used to rivet the ECU in place.
Using a 5 mm (3/16 inch) drill, remove the 3 rivets.
5
Remove the ECU bracket.
6
Disconnect the service part OCS electrical connector.
19. NOTE: Make note of the opening that the OCS components are being fed through on the seat cushion support assembly for installation purposes.
Remove the OCS from the seat cushion frame.
-
Feed the hose, pressure sensor, wire harness, electrical connector and ECU through the seat cushion frame support assembly.
20. If necessary, remove the 2 pin-type retainers and the mat.
Installation
All seats
1. Bend the pressure sensor bracket retaining ear back, so it will engage upon assembly.
Vehicles with heated seats
