Town Car V8-4.6L VIN V Flex Fuel (2006)
Seat Position Sensor: Service and Repair
SEAT POSITION SENSOR
Removal and Installation
WARNING:
-
Always wear safety glasses when repairing an air bag supplemental restraint system (SRS) vehicle and when handling an air bag module.
This will reduce the risk of injury in the event of an accidental deployment.
-
Never probe the connectors on the air bag module. Doing so can result in air bag deployment, which can result in personal injury.
-
To reduce the risk of personal injury, do not use any memory saver devices.
NOTE:
-
If a seat equipped with a supplemental restraint system (SRS) component is being serviced, the SRS must be depowered.
-
The air bag warning lamp illuminates when the RCM fuse is removed and the ignition switch is ON. This is normal operation and does not indicate
a supplemental restraint system (SRS) fault.
-
The SRS must be fully operational and free of faults before releasing the vehicle to the customer.
1. Position the driver seat all the way BACK and UP.
2. Position the passenger seat all the way FORWARD.
3. Depower the system.
4. Disconnect the seat position sensor electrical connector.
5. Remove the seat position sensor bolt.
-
To install, tighten to 9 Nm (80 lb-ft).
6. Remove the seat position sensor.
-
Press the sensor tab inward to release and remove the seat position sensor.