Town Car V8-4.6L VIN V Flex Fuel (2006)
6. NOTE: Use the holding feature to prevent the stud from turning while removing the nut.
Remove and discard the upper stabilizer bar link nut.
^
To install, tighten to 63 Nm (46 ft. lbs.).
7. NOTE: Use the holding feature to prevent the stud from turning while removing the nut.
Remove the lower stabilizer link nut and the stabilizer bar link.
^
Discard the nut.
^
To install, tighten to 55 Nm (41 ft. lbs.).
8. Detach the wheel speed sensor wiring harness retainer from the steering knuckle.
9. NOTE: Use the holding feature to prevent the stud from turning while removing the nut.
Remove and discard the upper ball joint nut.
^
To install, tighten to 150 Nm (111 ft. lbs.).
10. NOTE: Use the holding feature to prevent the stud from turning while removing the nut.
Remove the lower ball joint nut and then remove the wheel knuckle.
^
Discard the nut.
^
To install, tighten to 150 Nm (111 ft. lbs.).
11. To install, reverse the removal procedure.
12. Check and, if necessary, align the front end.
