Town Car V8-4.6L VIN V Flex Fuel (2006)
3. WARNING: Do not remove the center nut. This nut holds the upper spring mount in place, if this nut is removed the spring tension will
be released. Failure to follow these instructions may result in personal injury.
Remove and discard the 3 Shock absorber mounting bracket nuts.
^
To install, tighten to 30 Nm (22 ft. lbs.).
4. CAUTION: Do not allow the caliper and anchor plate assembly to hang from the brake hose or damage to the hose can occur.
Remove the bolts and position the caliper, pads and anchor plate assembly aside.
^
Support the caliper and anchor plate assembly using mechanic's wire.
^
To install, tighten to 160 Nm (118 ft. lbs.).
5. Remove the brake disc.
6. NOTE: The stabilizer bar links are under pressure when the suspension is in the REBOUND position.
Using a suitable Jack stand, raise the suspension arms until the pressure is released from the stabilizer bar links.
7. NOTE: Use the hex holding feature to prevent the stud from turning while removing the nut. remove and discard the upper stabilizer bar link nut.
^
To install, tighten to 63 Nm (46 ft. lbs.).
8. NOTE: Use the hex holding feature to prevent the stud from turning while removing the nut.
Remove the lower stabilizer bar link nut and the stabilizer bar link.
^
Discard the nut.
^
To install, tighten to 55 Nm (41 ft. lbs.).
9. Detach the wheel speed sensor wiring harness retainer from the wheel knuckle.
10. NOTE: Use the hex holding feature to prevent the stud from turning while removing the nut.
Remove and discard the upper ball joint nut.
^
To install, tighten to 150 Nm (111 ft. lbs.).
11. Remove the Shock absorber and spring assembly lower nut and flag bolt.
^
Discard the nut.
^
To install, tighten to 225 Nm (166 ft. lbs.).
12. Remove the Shock absorber and spring assembly.
13. NOTE: Tighten all retainers that clamp a bushing, with the weight of the vehicle on the wheels.
To install, reverse the removal procedure.
Disassembly and Assembly
Shock Absorber and Spring Assembly
