Town Car V8-4.6L VIN V Flex Fuel (2006)
3. Peel back the rubber splash shield and disconnect the wheel speed sensor electrical connector.
4. CAUTION: Do not allow the caliper and anchor plate to hang from the brake hose or damage to the hose can occur.
Remove the bolts and position the caliper and anchor plate assembly aside.
^
Support the caliper and anchor plate assembly using mechanic's wire.
^
To install, tighten to 160 Nm (118 ft. lbs.).
5. Remove the brake disc.
6. Remove the bolts and the wheel bearing and hub assembly.
^
To install, tighten to 100 Nm (74 ft. lbs.).
7. CAUTION: To avoid sensor or wiring damage, be sure to properly route the wheel speed sensor wiring in front of the stabilizer bar link.
NOTE: During reassembly, verify that the wheel speed sensor electrical connector is fully seated with an audible click, and that the rubber splash
shield is positioned back into place.
To install, reverse the removal procedure.
