lincoln Workshop Repair Guides

Lincoln Workshop Service and Repair Manuals

Manual Control Lever Shaft and Seal|Page 4969 > < Manual Control Lever Shaft and Seal|Page 4967
Page 4
background image

4. Slide the drive shaft back enough to index-mark the driveshaft, output shaft and the extension housing. Separate the driveshaft from the

transmission.

5. Remove the rear transmission insulator nuts.

6. Disconnect the RH H02S sensor connector.

7. Disconnect the RH catalyst monitor connector.

Manual Control Lever Shaft and Seal|Page 4969 > < Manual Control Lever Shaft and Seal|Page 4967