Town Car V8-4.6L VIN V Flex Fuel (2006)
Drive/Propeller Shaft: Service and Repair
Driveshaft
Material
Removal and Installation
1. With the vehicle in NEUTRAL, position it on a hoist.
2. Index-mark the driveshaft centering socket yoke and the rear axle pinion flange.
3. Index-mark the driveshaft and the transmission extension housing.
4. Remove the 4 rear axle pinion flange bolts.
^
To install, tighten to 112 Nm (83 ft. lbs.).
5. CAUTION: The driveshaft centering socket yoke fits tightly on the rear axle pinion flange pilot. Never hammer on the driveshaft or any of its
components to disconnect the yoke from the flange. Pry only in the area shown, with a suitable tool, to disconnect the yoke from the flange.
