Town Car V8-4.6L VIN V Flex Fuel (2006)
8. Cut the urethane adhesive applicator tip to specification.
9. NOTE:
-
Use either a high-ratio, electric or battery-operated caulk gun that applies the urethane adhesive with less effort and continuous bead.
-
Make sure that all gaps in the urethane adhesive are smoothed into one continuous bead.
Apply urethane adhesive over top of the existing urethane adhesive.
-
Apply the urethane adhesive to the top and sides of the windshield from the interior of the vehicle.
-
Apply the urethane adhesive to the bottom of the windshield from the exterior of the vehicle.
10. NOTE: The urethane adhesive cures for a minimum of 1 hour before testing for air or water leaks.
After the urethane adhesive has cured, check the windshield seal for air or water leaks through the urethane bead and add urethane adhesive as
necessary.
11. Position the front portion of the headliner.
12. Install the LH and RH sun visors and sun visor clips.
13. Install the LH and RH A-pillar trim panel.
