Town Car V8-4.6L VIN W (1997)
7. Inspect disc brake caliper locating pin and locating pin boots. If disc brake caliper locating pin is binding, remove and clean. Lubricate with
Silicone Brake Caliper Grease and Dielectric Compound D7AZ-19A331-A or equivalent meeting Ford specification ESE-M1C171-A.
8. Install wheel and tire assembly, using Rotunda Accutorq Lug Nut Sockets 164-R0303 or equivalent on 1/2 inch drive air impact wrench or torque
wrench to tighten lug nuts to 115-142 Nm (85-104 ft. lbs.).
CAUTION: Failure to tighten lug nuts in a star pattern may result in high rotor runout, which will speed up the development of brake roughness,
shudder and vibration.
9. Lower vehicle.
10. Pump brake pedal several times to position brake shoes and linings. Refill brake master cylinder with High Performance DOT-3 Motor Vehicle
Brake Fluid C6AZ-19542-AB or DOT-3 equivalent meeting Ford specification ESA-M6C25-A as necessary.
11. Road test vehicle.
